Before applying your BTS to any surface, the area must be cleaned using an appropriate degreaser. Be sure not to use any oil based solvents, as this will affect the adhesion of the sign to the surface.
Once sign has made contact with the surface, the sign will be adhered. Remove any masking tape or marking and clean sign
Position your BTS as per D3.6 instructions
STEP 1 - Apply a strip of masking tape along your chosen edge, run your nail along the edge to create a hinge. (In this example we have chosen to use the top edge of the sign)
STEP 2 - Using your masking tape hinge, flip sign over and peel backing paper off the adhesive.
STEP 3 - Wrap a lint free cloth around your thumb or fingers. Holding the opposite edge of the sign away from the surface, slowly begin working your way from side to side across the surface, (starting from the hinge edge) applying firm pressure with the cloth. Slightly overlap each stroke, making sure no air gets between the sign and the surface.
1 - Lightly mark on the surface the position of your BTS as per D3.6 instructions.
2 - Remove backing paper off adhesive tabs and add an appropriate amount of adhesive (eg liquid nails or silicone) to back of the sign. Ensure you do not use too much glue, as it will ooze out from behind the sign.
3 - Using your marking reference, position your BTS on the surface and apply pressure to allow tape to make contact with the surface as well as spreading the adhesive.
The tabs of adhesive tape will hold the sign in place untill the chosen adhesive cures.
If signs are not provided with adhesive, please ensure that appropriate adhesives are used and follow above recommended directions.